#cuttingtool #materials #steel #basics #hindi
My fb page - https://www.facebook.com/engineerashish/
Gear introduction -https://youtu.be/vMF22az-hn4
Facing and Turning - https://youtu.be/wJV0y9Oxndk
Gear Ratio - https://youtu.be/xB7_2Df1Dz8
Chamfering and Fillet- https://youtu.be/czjkaQbTmU8
Suspension System - https://youtu.be/HT2Kd6pIArE
Diesel Vs Petrol Engine - https://youtu.be/yicxeqykBhk
Units Conversion - https://youtu.be/m5yguPiWg_o
Machpherson Strut Suspension - https://youtu.be/Pz2ZU4iJ2Lg
Caster angle - https://youtu.be/mRp3jxpAgV8
Toe in & Toe out - https://youtu.be/wkMg3zLvX00
Camber angle - https://youtu.be/qvmzWtvRte8
Type of Clutches - https://youtu.be/5Gr6z55GtO0
Master Cylinder - https://youtu.be/4foA0hqdxy0
Below the car Bonnet - https://youtu.be/XgBokJgHO3U
In this video I've discussed the cutting tool types viz. Single point cutting tool and multi point cutting tool.
After this, I've discussed the properties of cutting tools viz. Hot hardness, wear resistance, toughness, thermal conductivity, coefficient of friction, thermal stability, cost.
At last I've discussed the commonly available tool materials viz.
Carbon tool steel, high speed steel (hss) , cast non ferrous alloys, carbides, ceramic or cemented oxides, diamond.
I've also discussed 18-4-1 HSS and 6-6-4-2 HSS.
The language used for Explanation is Hindi/Urdu but the presentation is made in English language.
Jai Hind.